Sorry - this product is no longer available

This is no longer available although you may find similar or newer versions below:

Bostitch 3.1 x 90mm 21° Stick Nails Smooth Shank Galvanised (2000)

Product Description

  • Collation is angled at 21° to accommodate the overlapping heads.

    Smooth shank nails have exactly that: a smooth appearance

  • Packs of 2000 Round head nails.

    These plastic collated stick nails traditionally have a full round head, while only giving marginally better holding power to clipped head nails, they are preferred by the construction industry

  • Due to their regular form they can be produced at very high speed and are therefore the most economical type of nail
  • They require less energy to drive them and the air consumption per nail can be lower
  • Again a difference in the diameter of the shank is produced making it even more difficult to withdraw the nail
  • Used in applications where no protection is required, for example a one way disposal pallet
  • Galvanised protection is measured in Microns (each Micron is 0.000001 of an metre thick)
  • The thicker the micron coating the better the protection level of the nails.

    Gauge/Diameter (mm) 3.1
    Length 90
    21° Collation Angle
    SKU RH3190G50
    Profile SMOOTH
    Finish G50
    Description RH STICK 3.10-90 PLAIN GAL-HD50 2M
    Qty per box 2000

    Will Fit F21PL-E, N79RH-2

  • The air consumption per nail is also higher, and the energy required to drive these nails into hard wood is very much greater.

    Bright finish is without any form of protection and is the most economical choice, but the nails will start to rust before nails that have a protective treatment

  • The thickest coating is called hot dipped and is applied by dipping the nails into a bath of molten zinc
  • However, their holding power is the lower than ring shank nails
  • The zinc does not protect the steel of the nail, but is corroded first
  • Sometimes it is possible to use a smaller tool to drive them.

    Ring shank nails have a series of rings punched into the surface of the shank

  • As all standard nails come with this finish.

    Galvanising , or coating with Zinc, is the best way to prevent nails from corroding

  • Ring shank nails have to be produced at lower speeds and their cost is generally higher than for a smooth shank nail
  • The thicker the zinc coating, the longer it will be before the nail is attacked

Manufactured by