- Once applied it penetrates and expands slightly on cure, really “sinking its teeth” into both substrates to form a virtually indestructible bond
- GATOR GLUE is the adhesive with real bite
- Fast setting, initial set in 30 minutes (full cure 24 hours)
- Exceptional bond strength to wood and most common building surfaces
- Products foam slightly on application to fill small gaps and increase overall bond strength
- Internal and external use - excellent weathering and aging properties
- Excellent Chemical Resistance.
Areas For Use
General wood jointing and construction
Bonds to wood, metal, stone, ceramics etc.
As a high quality insulation adhesive for foam/glasswool/fibre boarding
At least one of the surfaces to be bonded must be porous.
Not suitable for polyethylene, polypropylene, Teflon or Nylon.
Surfaces may be damp, but moisture content of wood must not exceed 30%w/w.
As product expands slightly on curing, do not use on sheet laminate. Use STICK 2 CONTACT ADHESIVE.
Only apply between + 5 and + 30 o
Ensure surfaces are always clamped during use.
Setting times will be increased at low temperatures and low humidity.
The surfaces to be glued should be clean and free from dust, grease and other contaminants. At least one of the materials must be porous. Roughen non-porous surfaces to give a key for the adhesive. To assist cure and achieve maximum bond strength, slightly moisten one surface with a damp cloth. Do not over wet.
Surfaces to be bonded must be clean, dust and grease free. One of the surfaces must be porous. Roughen non-porous surfaces (e.g. plastics) to give a key for the adhesive. Remove cap and cut tip of nozzle
Slightly moisten one surface with a damp cloth or water mist spray. Do not over wet.
Apply adhesive evenly to other surface.
Assemble parts IMMEDIATELY and clamp/weigh down for 30 mins before handling. After this time the joint may be easily handled. Final bond strength will be achieved after 24 hours. For small repairs, temporarily bind items together with MAMMOTH MEGA TAPE.
Replace cap on nozzle immediately after use.
NOTE: The product foams slightly on application to fill small gaps. Any excess foam/adhesive or tools must be removed/cleaned with acetone before the product sets. Cured adhesive may be removed with EVERBUILD FOAM EATER.
100% prepolymers and catalyst (solvent free)
100% (solvent free)
200 x10 3 mPa.s (bfld RVT sp7 5rpm) (gel)
400g/m², or 10 linear meters per tube (approx)
Initial Set Time
30 mniutes depending on product
Everbuild Gun Foam Cleaner or acetone BEFORE curing. After cure, use mechanical abrasion.
Health & Safety
Consult MSDS for full list of hazards.
Store in original unopened containers between 10 and 25 o C. Reseal immediately once used or disposal will be necessary
18 months from date of manufacture in original unopened containers.
The technical data contained herein is based on our present knowledge and experience and we cannot be held liable for any errors, inaccuracies, omissions or editorial failings that result from technological changes or research between the date of issue of this document and the date the product is acquired. Before using the product, the user should carry out any necessary tests in order to ensure that the product is suitable for the intended application. Moreover, all users should contact the seller or the manufacturer of the product for additional technical information concerning its use if they think that the information in their possession needs to be clarified in any way, whether for normal use or a specific application of our product. Our guarantee applies within the context of the statutory regulations and provisions in force, current professional standards and in accordance with the stipulations set out in our general sales conditions. The information detailed in the present technical data sheet is given by way of indication and is not exhaustive. The same applies to any information provided verbally by telephone to any prospective or existing customer.