View Large & Mouseover to Zoom
thmbnil
thmbnil
thmbnil
GURE18643 Husqvarna Viking

Husqvarna Viking Overlocker Piping Foot with Corded Guide Husqvarna Viking Overlocker Presser Feet

by Husqvarna Viking
£19.99

£0.39 credit back reward with this item.

19.99
  • Husqvarna Viking Overlocker Piping Foot with Corded Guide. Easily create your own piping:1. Set the machine for Chainstitch.2. Use the default stitch settings. Adjust if needed. Note: Although the machine recommends needle D, you will use needle E for this technique instead.3. Snap on the Piping foot. (The cording guide is not used for this technique.)4. Place the cord in the groove on the bottom of the foot and pull the cord tail behind the foot about 2½” (5cm). Note: ¼” - 5/8” (1.5 - 2.0mm) cord can be used.5. Cut a strip of fabric on the bias, 1” (25mm) wide.6. Wrap the fabric around the cord in the front of the foot. Slide the fabric under the foot.7. Lower the presser foot and sew over the cord and fabric. (Hold the cord behind the foot as you begin to sew.)Corded TucksAchieve a trapunto effect when a coverstitch is sewn over a cord in the guide.1. Set the machine for coverstitch, wide. Note: Although the machine recommends needles C and E, you will use needles D and E for this technique instead.2. Snap on the Piping foot and attach the cording guide.3. Insert the cord into the round hole of the cording guide and position it in the groove on the bottom of the Piping foot.4. Lay the fabric right side up on top of the cord. Slide it under the foot until it is underneath the needles.5. Lower the needles into the fabric. Lower the presser foot and start to sew at a medium speed. (Hold the cord behind the foot as you begin to sew.)Decorative TrimUse decorative thread and ribbons to create special effects and unique trims.1. Set the machine for 3-thread ornamental fl atlock stitch, wide with decorative thread in the loopers.2. Snap on the standard presser foot and attach the cording guide as illustrated.3. Insert a ribbon ¼” (6mm) wide right side down into the rectangular opening in the guide.4. Place the ribbon under the presser foot to the right side of the needle, leaving a 2” (5cm) tail behind the foot.5. The needle should go down into the machine just beyond, not into, the edge of the ribbon.6. Sew over the ribbon to make a decorative trim. Tip: Make your decorated
Quantity:
  • Usually Despatches Within 3 Working Days
Dispatched & sold by: GUR Enterprise UK Ltd
facebook

Description

Warning

  • Domestic Use Only. Not suitable for Children Under 36 Months.

Warranty

  • Husqvarna Viking 10 Year Warranty HV03
  • HCODE

    GURE18643

  • MPN

    620097096

  • MANUFACTURER

    Husqvarna Viking

  • EAN CODE

    7393033074432

  • CONDITION

    NEW

Dialog example

This is dummy copy. It is not meant to be read. It has been placed here solely to demonstrate the look and feel of finished, typeset text. Only for show. He who searches for meaning here will be sorely disappointed.

Dialog example

This is dummy copy. It is not meant to be read. It has been placed here solely to demonstrate the look and feel of finished, typeset text. Only for show. He who searches for meaning here will be sorely disappointed.